Peaty's Workshop Rim Job Tubeless Tape, 25mm/50m
Both riders and mechanics themselves and scientists participated in the development of Peaty's Rim Job rim tape.
The tape has high tensile strength, but thanks to its optimally tuned extensibility and adhesive layer
It adheres perfectly to the inner wall of the rim as if it were part of it. Do you usually have trouble finding a hole for
valve? With Peaty's Rim Tape, you can forget about this complication. The transparency of the tape
always leads with certainty.
Assembly instructions:
1. After removing the tire, remove the old tape from the rim.
2. Clean the inner wall of the rim thoroughly with an alcohol-based degreaser.
3. Before applying the tape, make sure the rim is dry and free of all dirt.
4. Start about 10 cm from the valve opening and work your way towards it. Tape tightly
Press into the center of the inner wall of the rim and smooth out towards the edges. Push out all trapped air.
5. Proceed in the same way around the entire circumference of the rim, again with an overlap of approximately 10 cm beyond the valve hole.
6. Pierce the tape with a sharp tip in the center of the valve hole.
7. Install the MK2 valve.
8. Install the tubeless tire, fill it with Peaty's Tubeless Sealat.
Inflate the tire to a higher pressure than you drive.
9. Shake the inflated tire thoroughly and let it sit.
10. Before driving, release the pressure to the desired driving value.
Tape width | 25 mm |
product ID | 352887 |

There are currently no reviews