Fenix ​​CL26R PRO rechargeable lamp, marble

Fenix ​​CL26R PRO is a practical portable rechargeable lantern that you can use to light a room, tent, campsite, caravan, cottage, boat or work table. In addition, it has a power bank function, so it can be used to charge other USB devices. The lantern offers the function of circular lighting and bottom lighting, individual light modes are switched with a rotary control. In addition, both lighting methods can be combined to achieve a total output of up to 650 lumens.

The CL26R PRO is powered by a Li-ion battery type 21700 with a capacity of 5000 mAh (included in the package), which is charged directly in the lantern using the USB-C connector and supplies energy for up to 408 hours of operation in the lowest mode. There is also red light, which does not disturb the adaptation of the eyes to the dark.

Front one-way lighting and bottom lighting are very practical functions that significantly save energy. They are particularly suitable in situations where circular omnidirectional lighting is not required.

Thanks to the durable and impact-resistant construction with IP66 protection, the lamp can be safely used even in adverse weather (heavy rain). The upper side of the lantern is equipped with a hanging eye that can be opened like a carabiner and a strong neodymium magnet, so it can be easily hung or attached to anything iron. Thanks to its compact dimensions, the lantern is particularly suitable for camping and hiking, but you can also use it in a caravan, on a boat or in a cottage.

All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

Parameters of the Fenix ​​CL26R PRO rechargeable lantern

• The light source is highly bright SMD diodes and red LEDs.
• Six circular lighting modes: 500 lumens (10 hours) -> 200 lumens (13 hours) -> 50 lumens (40 hours) -> unidirectional lighting 25 lumens (67 hours) -> red light 3 lumens (125 hours) -> red flashing 3 lumens (240 hours)
• Three modes of bottom lighting: 150 lumens (15 hours) -> 50 lumens (58 hours) -> 5 lumens ( 408 hours ).
• Circular and bottom lighting modes can be combined to achieve a total output of up to 650 lumens.
• Electronics with the function of extended lighting time and protection against the reverse insertion of batteries.
• It is powered by 1x Li-ion battery 21700 with a capacity of 5000 mAh (included in the package), any 21700 battery from our offer can be used as a replacement.
• Charging via USB-C connector.
• Powerbank function with USB-A output connector for charging other portable electronics with USB charging.
• Made of durable plastic, the lantern is impact-resistant when dropped from a height of 1 meter.
• Waterproof according to the IP66 standard (spraying with strong streams of water from all directions).
• The omnidirectional diffuser creates a wide uniform light cone with a range of up to 15 meters.
• The upper side is equipped with a hanging eye with a carabiner function and a neodymium magnet for attaching to anything iron.
• Dimensions 6 cm (diameter) x 6.6 cm (at the widest point including the controller) x 11.4 cm (height).
• Weight 272 grams (including battery), 199 grams (without battery).
• The package includes a lantern, a Fenix ​​ARB-L21-5000 V2.0 battery, a spare o-ring and a USB-C cable.
• It is also possible to purchase a USB adapter for the mains and a USB adapter for the car.

The use

From the factory, there may be an insulating cap inside the lantern on the battery. Before first use, remove it from the battery.

Turning the switch clockwise turns on the main circular light. Turning the switch counterclockwise turns on the bottom light. By turning the switch in the selected direction, the lighting modes of the switched on light are switched. Turning the switch to the middle "off" position turns the lantern off again.

Combination of main and lower light - main and lower light can be combined. Turn one of them with the rotary switch to the desired performance mode. The second light is then switched on by holding the electronic switch for 0.5 s, its modes can be switched further by pressing the button.

When the lantern is off, the red light is turned on and off by holding down the electronic switch for 0.5s. Switch between red light modes by pressing a button.

Battery charge status indication - after a short press of the button (the lantern must be switched off), the LED charge status indicator above the switch is activated. Four lit LEDs mean the battery is 80-100% charged, three lit 60-80%, two lit 40-60%, one 20-40% and one flashing means the battery is less than 20% charged.

Powerbank function

Flip off the dust cover and insert the USB cable into the USB type A discharge port on the lamp, then connect the other end of the cable to the USB device you want to charge. If the lantern is on, the power bank function is activated automatically after connecting the USB cable. If it is off, press the electronic switch, the indicators will move from right to left and show the status. During discharge, it is not possible to use the highest power or to combine the main and lower light modes. Be sure to seal the dust cap after charging is complete. If the battery voltage is too low, the power bank function is switched off.

Charging the Fenix ​​CL26R PRO lantern

To charge the lantern, unfold the dustproof rubber cover. Connect the lantern with the included USB-C cable to a computer, a USB mains adapter or a USB car adapter. A standard mobile phone charger or power bank can also be used for charging. During charging, the indicator LEDs above the switch flash to show the charging progress. They will remain lit after charging.

The battery does not suffer from a memory effect, so it can be recharged at any time and there is no need to wait until it is discharged. Charging a fully discharged battery takes about 3.5 hours (depending on the power of the charging source used).

During charging, the lantern can only be turned on in 5, 25 and 50 lumen mode.

Warning

• Do not disassemble the sealed parts yourself, this will void the warranty.
• If the light flickers, does not switch to higher power modes, or does not light up, it may be for one of the following reasons:
  
  • The battery is almost empty - charge it.
  • The electrical contacts are dirty - clean them with a cotton swab dipped in alcohol.
  • The battery cap is loose, tighten it.

Output: 650lm
Max. durability: 408 hours
Afterlight: 15m
Number of modes: 9
Weight: 272g
Power supply: 1x 21700
Light source: SMD diodes
Waterproof: IP66 (heavy rain)