Fenix C7 rechargeable light

Fenix ​​C7 rechargeable flashlight

Fenix ​​C7 is a high-performance rechargeable lamp that offers a luminous flux of up to 3000 lumens (ANSI) and an afterglow of up to 470 meters. This excellent performance was achieved by using a modern LED Luminus SST-70. It is powered by a high-capacity Li-ion battery type 21700 with a capacity of 5000 mAh (included in the package), which is charged directly in the lamp via a modern USB-C connector. The lamp was designed with ease of use and wide applicability in mind. Seven light modes allow you to choose between high performance and a long duration of almost three days. There is also a blinding strobe light and an SOS signal for emergencies. Fenix ​​C7 is powered by a digitally controlled constant current to guarantee constant light output even when the voltage in the batteries is reduced (while they are slowly discharged). Switching on and switching modes is very easy and is done with a button ergonomically placed on the side. The end of the lamp is magnetic, so it can be easily attached to anything iron. The lamp is an ideal lighting tool with an excellent ratio of high performance, quality and price. Thanks to its versatility, it can be recommended for work in industries, for the home workshop, but at the same time it is an ideal outdoor partner for hiking and various sports activities. All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

The use

From the factory, there may be an insulating cap inside the lamp on the battery. Remove it from the battery before first use.

To turn it on or off, hold down the side button for about 0.5 seconds. Power modes 30 - 100 - 400 - 1400 - 3000 lumens can be switched at any time during operation by pressing the side button. You can start the strobe by pressing the button for 1.2 seconds (possibly even from the off state), then by pressing the button further you can switch between the strobe and SOS modes.

Charging - unfold the rubber cover of the charging connector on the side of the lamp and plug in the enclosed cable (USB-C connector), plug the other end of the cable into a computer or USB adapter into the electrical network or car. During charging, the indicator LED lights up red, after full charge it lights up green. Charging a fully discharged battery takes about 3 hours (with a 2A power supply).

Intelligent protection against overheating - if the temperature of the lamp rises above 60 °C, it will automatically reduce the power in gradual steps, as soon as the temperature of the lamp drops below 60 °C, the power will gradually increase again.

Battery charge status indication - after a short press of the button (the lamp must be switched off), the LED indicator in the button is activated. If the indicator light is green, the battery is more than 85% charged. Green flashing means 50-85% capacity. If it lights up red, the battery is charged to 25-50%. Blinking red means less than 25% of battery capacity remains.

Locking the button - if you want to prevent unwanted switching on of the lamp in the luggage, press the button twice quickly for 0.5 seconds (the lamp must be turned off), then the lamp will flash twice in low mode and cannot be turned on. To unlock, quickly double-press the button again. Unwanted switching on can also be prevented by opening the battery cap of the lamp.

Warning of discharged battery - the side button starts flashing red and the light gradually automatically switches to the lowest mode.

Warning

• Do not disassemble the sealed part in the lamp head yourself, this will void the warranty
• Use only high-quality Li-ion batteries 21700 to avoid damage to the lamp, for example due to leakage of substances from the battery
• If the protective rubber rings appear damaged after a long period of use, replace them. The rings must also be lubricated to prevent rubber erosion. By following these rules, the lamp will be properly protected against water.
• If the lamp flashes, does not switch to higher power, or does not light up, it may be for one of the following reasons:
  
  • The battery is dead, charge it
  • The contacts inside the lamp are dirty - clean them with a cotton swab dipped in alcohol
  • The lamp body is loose, tighten it