Ghost Lector 10 ULC darkred/red 29" (darkred/red), model 2016
Fork: Fox 32 Float Factory Kashima Remote 100mm 15mm
Stem: Race Face Turbine 31.8 mm
Handlebars: Race Face Next Carbon 720 mm 31.8 mm
Derailleur: Shimano XTR 11-Speed DI2
Derailleur (tensioner*): Shimano XTR DI2
Shifting: Shimano XTR SL DI2
Cranks: Shimano XTR 36-26
Cassette: Shimano XTR 11-40
Chain: Shimano XTR
Brakes: Shimano XTR CC Disc 180-160 mm SMRT 86
Tires: Schwalbe Rocket Ron/Thunder Burt Evo 2.25
Rim: Tune
Front hub: Tune King 15mm
Rear hub: Tune Kong 12mm
Seat post: GHOST SL Carbon 31.6 mm
Saddle: SDG Circuit
Front stroke: 100 mm
Model year | 2016 |
Gears | 2x11 |
Groupset | Shimano XTR, Shimano XT |
Material | carbon fiber |
product ID | 13923 |
All bicycles at the MTBIKER shop are new, not-ridden, from an official distributor and with a full warranty. Several brands even offer a lifetime warranty on the frame after registration. We perform all warranty services in MTBIKER stores after personal delivery or after sending the bike (or its part) by courier.
- The bicycle is taken out of the manufacturer's box
- The bicycle is assembled, inspected and adjusted (front and rear derailleur, shock, fork, wheels,...)
- The bicycle is carefully packed back into a box and shipped
- If you order a bicycle for in store pick up or home delivery, the bicycle will be waiting put together, checked and ready to use for you.
- If you order a bicycle via courier to your home address, the following must be done at home:
- Take the bike out of the box and carefully remove safety material and foils
- Mount handlebar to stem (1 minute, 4 or 5 mm hex hey is needed).
- Mount front wheel to fork (1 minute, without the need of any tools if the bike has a quick release).
- Loosen the screws in the headset, straighten the stem with the front wheel, tighten the upper screw on the fork and then tighten the headset (2 minutes, 4 or 5 mm hex key is needed).
- Mount the pedals to the cranks while lubricating the thread and carefully mounting it the right way (1 minute, 8 mm hex key or 15 mm wrench).
- Mount seatpost to frame (10 seconds, without needing any tools if the frame has a quick link).
- Inflate the tyres or fork and shock to desired pressure (2 minutes, pump needed).
- Check the tightening of hex keys and quick-releases (2 minutes, 4 and 5 mm hex key is needed).
- Go for a test drive! Handle your bicycle carefully until you get used to it. If the bike has disc brakes, their performance will be limited from now on - they will gain their full power after 4-5 strong brakes at higher speed.

There are currently no reviews