Bike forks with suspension

The FOX 38 Factory Grip X2 29" is a new generation top-of-the-line enduro and all-mountain suspension fork for the 2027 model year. It is designed for the most demanding riding, where maximum sensitivity, stability and consistent performance are required on long and technical descents. Instead of further increasing stiffness, it focuses on significantly reducing friction, smoother running, and better response in broken terrain.The new GlideCore air spring delivers greater compliance and sensitivity to small bumps, while generatively designed lower legs with increased bushing overlap reduce friction under side loads and extend service intervals. Combined with the updated GripX2 shock cartridge, MCU anti-rebound bumper, and improved bleed system, the FOX 38 is ready for aggressive enduro tracks and bike park use.The fork is optimized for 29" wheels, uses a floating axle for precise guidance, and supports a wide range of brake disc diameters, including a specific mount for the ABS sensor. Thanks to its mudguard compatibility and emphasis on proper SAG and low-speed compression settings, it offers precise tuning to suit riding style and conditions. Intended for: All-Mountain and Enduro riding, aggressive downhill and technical terrain GlideCore air spring: new design with both horizontal and vertical compliance for greater sensitivity Increased bushing overlap: generatively designed lower legs with increased bushing overlap by 20 mm for lower friction and longer service interval MCU Bottom-Out Bumper: integrated bumper for progressive end-of-stroke control on hard impacts Updated GripX2 cartridge: advanced cushioning with improved compression control for stability and responsiveness Improved air vents: new location of bypass channels and valves for effective air pressure equalization Generative leg design: optimized stiffness of the bridge and lower legs for better maneuverability Mudguard compatibility: same mounting system as on the 36 and 36 SL models Damping cartridge: GripX Stroke: 170 mm Wheel diameter: 29" Inner leg finish: Genuine Kashima Coat Axle: 15 x 110 mm Floating Axle Offset: 44 mm Weight: approximately 2200 g Brake disc: support for 180 - 230 mm rotors, ABS mount available Maximum tire width: up to 2.6" Adjustment recommendation: after adjusting the SAG, fine-tune the low-speed compression (LSC) and regularly use the bleed valves when changing temperature or altitude ABS Mount: specific mount for the ABS sensor