Fenix UC35 XP-L rechargeable flashlight

The second generation of the Fenix ​​UC35 V2.0 rechargeable tactical flashlight is equipped with the latest LED Cree XP-L HI V3 and brings a luminous flux of up to 1000 lumens in (ANSI) and an afterglow of up to 266 meters. The package also includes a rechargeable 18650 Li-ion battery with a capacity of 3500 mAh, which is charged directly in the lamp via the side micro -USB connector. Alternatively, the lamp can be powered by two disposable CR123A batteries. The Fenix ​​UC35 flashlight has six different lighting modes that allow you to choose between high performance and long endurance. At the lowest moonlight mode , it can shine for up to 800 hours, which is more than 33 days. There is also a stroboscopic flash mode for crisis situations. The lamp is powered by a digitally regulated constant current to guarantee a constant light output even when the voltage in the batteries is reduced (while they are gradually discharging). In addition, the lamp is equipped with an indication of the state of charge of the batteries in the side button.

The second generation Fenix ​​UC35 V2.0 flashlight impresses not only with smaller dimensions and extended afterglow, but also with a tactical switch and the possibility of attaching the AER-02 V2.0 cable switch. We can therefore recommend it also for use in security forces, for hunting and other demanding activities.

All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

Fenix ​​UC35 XP-L flashlight parameters

• A high-performance Cree XP-L HI V3 LED with a lifespan of 50,000 hours is used.

• Six lighting modes: Turbo 1000 lumens ( 2.25 hours) -> 350 lumens (4.1 hours ) -> 150 lumens (10.6 hours) -> 50 lumens (28.1 hours) -> 1 lumen ( 800 hours ) - Strobe 1000 lumens (strobe with variable frequency).

• Luminous flux and endurance times are measured with the included Li-ion 18650 battery with a capacity of 3500mAh.

• Due to the mechanical protection against polarity reversal , the accumulators must have a protruding plus pole. Older Fenix ​​accumulators with a flat positive pole cannot be used .

• The lamp is equipped with protection against overheating .

• Digitally regulated for constant brightness, low battery warning. Supported supply voltage 3 - 6V.

• Rechargeable Li-ion batteries of the 18650 type can be purchased as a spare battery.

• Two disposable CR123A type lithium batteries can alternatively be used for power supply (do not try to charge them in the flashlight).

• Protection against accidentally inserting the battery upside down (reverse polarity).

• Dimensions 14.0 cm (length) x 2.54 cm (reflector diameter) x 2.35 cm (body diameter).

• Weight 89 grams ( without batteries), 139 grams including battery.

• Made of aviation hardened aluminum type T6, durable surface - Type III hard anodized.

• Impact-resistant from a fall from a height of 1 meter.

• The flashlight has a memory and will always turn on in the last set mode (does not apply to flash modes).

• Trapezoidal threads with increased wear resistance.

• Pronounced grooved surface for a better grip, the design prevents the lamp from rotating on an uneven surface.

• Water resistant and dust resistant according to the IP68 standard (tested under water at a depth of 2 meters for 30 minutes).

• Removable steel buckle with titanium finish.

• Hardened ultra clear glass lens with anti-reflective surface.

• Smooth parabolic reflector for a light cone with an afterglow of m 266 meters ( 17700 cd).

• Tactical switch at the end of the flashlight (momentary on/off function).

• The flashlight comes with a wrist strap, a belt pouch, a Fenix ​​18650 battery with a capacity of 3500 mAh, a USB cable and spare o-rings.

• Optional accessories can be purchased, for example: cable switch AER-02 V2.0, red traffic cone AOT-S, diffuser AOD-S, red filter AOF-S+, green filter AOF-S+, blue filter AOF-S+

• The flashlight can also be attached to a long weapon using the ALG-15 Quick Release Weapon Rail Mount, the Fenix ​​ALG-00 Weapon Rail Mount, the Metal Magnetic Mount, and the Plastic Magnetic Mount.

• The lamp can also be purchased with a USB mains adapter and a USB car adapter, a bicycle holder, a special Fenix ​​bicycle holder, a BikeBlock bicycle helmet lamp holder, an AB02 rotating case and an ALP-MT case.

Product reviews

Simple operation and unprecedented brightness performance are just some of the features of the Fenix ​​UC35 XP-L flashlight. You can read about the possibilities of its use in the security force and outside it in the review at tydenikpolicie.cz

The use

From the factory, there may be a black insulating cap inside the lamp on the battery. Remove it from the battery before first use. To turn it on, press the switch located at the end of the lamp, for immediate activation, press the button. By pressing the side button at the light head, you can switch between power modes at any time during operation. To switch to strobe mode, hold down the side button for about 0.5 seconds.
Intelligent protection against overheating - if the temperature of the light rises above 60°C, it will automatically reduce the power in gradual steps until its temperature stabilizes. As soon as the temperature of the lamp drops below 60°C, the power will automatically increase to the original level again. Operation at the highest power mode is thus not limited by time, but only by temperature.
Indication of the state of charge of the batteries - each time it is switched on, the indicator LED in the side button of the lamp is activated for three seconds. If the indicator light is green, the battery is charged to more than 85%. Green flashing means 50-85% capacity. If it lights up red, it is charged to 25-50%. Blinking red means there is less than 25% battery capacity left. (Only works when using Li-ion 18650 battery).
Charging - unfold the rubber cover of the charging connector on the side of the lamp and plug in the enclosed cable (micro USB connector), plug the other end of the cable into a computer or USB adapter into the electrical network or car. The side button lights up red while charging. It lights up green when fully charged. Charging a fully discharged battery takes about 3.5-4 hours. While charging, the light can be used, but only in the 50 lumen mode.
Warning of discharged batteries - the lamp will gradually automatically switch to the lowest mode and the indicator LED in the side button will start flashing red.

Warning

• Do not disassemble the sealed parts in the flashlight head yourself, this will void the warranty.

• When using disposable CR123A batteries , do not try to charge them in the lamp .

• If the protective rubber rings appear to be damaged after a long period of use, replace them. The rings must also be lubricated to prevent rubber erosion. By following these rules, the lamp will be properly protected against water.

• If the lamp flashes, does not switch to higher power modes or does not light up, it may be for one of the following reasons:

  • The batteries are almost empty - replace them or charge the accumulator.

  • The contacts inside the lamp are clogged - clean them with a cotton swab dipped in alcohol.

  • The head, body or back of the lamp is loose - add lubricant to the sealing rings and tighten the head and the end of the lamp.

Warranty

Five-year warranty for the lamp, two-year warranty for the battery.

Max power: 1000 lm

Max endurance: 750 hrs

Aftersight: 266 m

Number of modes: 6

Weight: 139 g

Power supply: USB

Power supply: 2xCR123A

Power supply: 1x18650

Light source: Cree XP-L HI

Waterproof: IP68 (immersion 2 m)