Fenix ​​HT30R rechargeable laser light

The Fenix ​​HT30R rechargeable laser light belongs to the tactical lights with the largest afterglow in the offer. Its white laser light with a power of 500 lumens (ANSI) creates an extremely focused beam that is capable of illuminating up to a distance of 1500 meters. The light source is a white laser with LEP (laser excited phosphor) technology, which is known for its use primarily in the automotive industry for the most luxurious vehicles. One Li-ion battery type 21700 with a capacity of 5000 mAh (included in the package) is used for power supply, which is charged via a USB-C connector built directly under the thread of the lamp head. The lamp is thus fully waterproof and dustproof according to the IP68 standard (tested under water at a depth of 2 meters). In case of emergency, it is also possible to use an 18650 battery with an ALF-18 reduction (not included in the package). The lamp has two levels of white light output with a duration of more than 7 hours and there is also a stroboscopic flashing mode. The flashlight uses a dual tactical switch that allows for faster and more reliable control in crisis situations. For example, it can be quickly turned on directly into stroboscopic mode. The light flux is concentrated in a narrow cone, which makes all the light fall on a specific target, and the lamp is thus ideal for hunting and illuminating distant targets.

All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

Fenix ​​HT30R lamp parameters

• A white laser with LEP technology (laser excited phosphor) with a lifetime of 50,000 hours is used.
• Three lighting modes: 500 lumens (2.3 hours) -> 100 lumens (7.25 hours) -> Strobe 500 lumens.
• Smooth reflector for a light cone with an afterglow of 1500 meters (600000 cd).
• The endurance times are measured with a rechargeable Li-ion battery 21700 with a capacity of 5000 mAh.
• Electronics with digital power regulation, protection against reverse insertion of batteries and protection against too deep battery discharge.
• One Li-ion battery 21700 5000 mAh (included in the package) is used for power supply. In an emergency, it is possible to use one Li-ion battery type 18650 with the ALF-18 reduction (not included in the package).
• Dimensions 17.9 cm (length) x 4 cm (head diameter) x 2.6 cm (body diameter).
• Intelligent protection against overheating.
• The lamp has a memory and will turn on in the last set mode (does not apply to flash mode).
• The body of the lamp is made of aviation hardened aluminum type A6061-T6.
• Durable hard-to-scratch surface - Type III hard anodized.
• Impact-resistant from a fall from a height of 1 meter.
• Trapezoidal threads highly resistant to wear.
• Weight 264 grams (including battery).
• Waterproof and dustproof according to the IP68 standard (tested under water at a depth of 2 meters).
• Hardened ultra clear glass lens with anti-reflective coating.
• The battery stored between two springs - easily withstands recoil when used on a weapon.
• Tactical switch at the end of the lamp (momentary on/off function).
• The lamp comes with an ARB-L21-5000 battery, USB-C charging cable, wrist strap, belt pouch, spare o-ring.
• Optional accessories can be purchased: cable switch AER-05, red traffic cone AOT-L, red filter AOF-L, green filter AOF-L, blue filter AOF-L, white diffuser AOT-02.
• The following accessories are also compatible with the light: Fenix ​​ALD-05 strap for use of the light on a helmet, ALG-15 quick-release weapon rail mounting, quick release rail mount ALG-00, M-LOK mount Fenix ​​ALG-16, barrel mount Fenix ​​ALG-18, barrel mount, metal magnetic barrel mount, plastic magnetic barrel mount, light mount on optics, metal mount on optics.
• The lamp can also be purchased with a USB adapter for the mains and a USB adapter for the car.

Fenix ​​HT30R lamp control

From the factory, there may be an insulating cap inside the lamp on the battery. Before first use, remove it from the battery.

To turn it on, press the larger tactical button located at the end of the lamp, for immediate activation, hold the button. By pressing the secondary switch button, you can switch between power modes at any time during operation. To switch to flash mode, hold down the switch button for approximately 0.5 seconds while the light is on. Press and hold the toggle button to turn the light directly into strobe mode.

Indication of the state of charge of the batteries - every time it is switched on, the indicator LED at the charging connector is activated for three seconds. Green flashing means 30-100% capacity. Red flashing means that less than 30% of the battery capacity remains (only works when using 21700 and 18650 Li-ion batteries).

Charging the lamp - slightly unscrew the head of the lamp, this will expose the charging USB-C connector. Plug the included USB-C cable into it and plug the other end into a computer, USB network adapter or USB car adapter (not included). Any mobile phone charger with a USB-C connector can also be used for charging. During charging, the indicator LED opposite the charging connector lights up red, after full charge it lights up green. Charging a fully discharged battery takes about 3 hours. The used Li-ion battery does not suffer from a memory effect, so the lamp can be recharged at any time. The lamp cannot be turned on during charging.

Intelligent protection against overheating - if the temperature of the lamp rises above 60 °C, it will automatically reduce the power in gradual steps.

 Upozornenie

• Use only high-quality rechargeable Li-ion batteries with protective electronics.
• Insert the batteries with the positive pole towards the lamp head.
• If the protective rubber rings appear damaged after a long period of use, replace them. The rings must also be lubricated to prevent rubber erosion. By following these rules, the lamp will be properly protected against water.
• If the light flickers, does not switch to higher power modes, or does not light up, it may be for one of the following reasons:
  
  • The battery is almost empty - charge it or replace it.
  • The contacts inside the lamp are dirty - clean them with a cotton swab dipped in alcohol.
  • The head, body or back of the lamp is loose, tighten them.

Aftersight: 1500m
Max. duration: 7.2 hours
Output: 500lm
Number of modes: 3
Weight: 264g
Power supply: 1x 21700
Power supply: USB charging
Light source: LEP (laser excited phosphor)
Waterproof: IP68 (immersion 2 m)