Fenix ​​PD36R PRO tactical rechargeable flashlight

The Fenix ​​PD36R PRO rechargeable tactical flashlight offers a top luminous flux of up to 2800 lumens (ANSI) and an afterglow of 380 meters. The lamp is powered by one Li-ion battery type 21700 (included in the package), which is charged directly in the lamp via a modern USB-C connector and supplies energy for up to 42 hours of lighting. The Fenix ​​PD36R PRO LED flashlight uses a dual tactical switch that enables faster and more reliable control in crisis situations. For example, it can be quickly switched directly into stroboscopic mode with a variable frequency. The lamp head is equipped with a striking rim. Thanks to this, the lamp can be used to break through glass in crisis situations or for self-defense. The robust design allows the lamp to be used on long weapons, so it is suitable for professionals, armed forces and hunting.

All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

Parameters of the Fenix ​​PD36R PRO LED lamp:

• A powerful Luminus SFT-70 LED with a lifespan of 50,000 hours is used.
• Six power modes: 2800 lumens (3.5 hours) -> 1000 lumens (3.9 hours) -> 350 lumens (8.25 hours) -> 150 lumens (19 hours) -> 30 lumens ( 42 hours ) -> strobe (stroboscopic flashing with variable frequency).
• It is powered by a 21700 Li-ion battery (included in the package).
• Endurance times are measured with a rechargeable 21700 Li-ion battery with a capacity of 5000mAh.
• Patented intelligent protection against overheating.
• The lamp has a memory and will always turn on in the last set mode (does not apply to the strobe).
• Dimensions 14.6 cm x 25.7 cm x 26.5 cm.
• Weight 169 grams including battery.
• Made from aircraft hardened A6061-T6 aluminum.
• Afterlight of 380 meters (36,600 cd).
• Impact resistant to a fall from a height of 1.5 meters.
• Durable hard-to-scratch surface - Type III hard anodized.
• Waterproof and dustproof according to the IP68 standard (tested under water at a depth of 2 meters for 30 minutes).
• Dual tactical switch at the end of the lamp (momentary on/off function).
• Fixed clip for safe and easy carrying of the lamp (removable).
• Due to its design, the lamp does not rotate when placed.
• The flashlight comes with a Fenix ​​ARB-L21-5000 battery, a USB-C charging cable, a wrist strap, a belt pouch and a spare o-ring.
• Optional accessories available: AER-05 cable switch, ALG-15 quick-release gun rail mount, ALG-00 quick-release rail mount, Fenix ​​ALG-16 M-LOK mount, Fenix ​​ALG-18 barrel mount, barrel, metal magnetic barrel mount, plastic magnetic barrel mount, light mount on optics, metal mount on optics, AOD-S V2.0 white diffuser, Fenix ​​ALD-05 strap for helmet light use, Fenix ​​bike mount, mount for FB-1 bicycle, case ALP-10S.

The use

From the factory, there may be an insulating cap inside the lamp on the battery. Remove it from the battery before first use.

To turn on/off, press the larger tactical button located at the end of the light, for immediate activation, hold the button. By pressing the secondary switch button, you can switch between power modes at any time during operation. To switch to flash mode, hold down the switch button for approximately 0.5 seconds while the light is on. Press and hold the toggle button to turn the light directly into strobe mode.

Intelligent protection against overheating - due to the fact that the lamp reaches a huge output of 2800 lumens, the temperature rises. If the temperature exceeds 60°C, the power will be automatically reduced. As soon as the temperature drops below 60°C, it is possible to use the highest power again.

Battery charge status indication - the lamp always indicates the battery charge status for three seconds after switching on. Green indicates a sufficient state of charge (100% - 85%), green flashing 85% - 50%, steady red light 50% - 25%, and flashing red indicates a critically discharged battery (25% or less). If the battery is discharged, the lamp will gradually automatically switch to lower power modes, in the lowest mode it will flash 3 times every five minutes.

Charging - unfold the rubber cover of the charging connector on the side of the lamp and plug in the attached cable (USB-C connector), plug the other end of the cable into the computer, or the USB adapter into the electrical network or car. The side indicator lights up red while charging. It lights up green when fully charged. Charging a fully discharged battery takes about 4 hours. The lamp cannot be used while charging.

Warning of exhausted batteries - the lamp will gradually automatically switch to the lowest mode.

Warning

• Use only high-quality rechargeable batteries of the type 21700 with protective electronics.
• Insert the batteries with the positive pole towards the lamp head.
• If the protective rubber rings appear damaged after a long period of use, replace them. The rings must also be lubricated to prevent rubber erosion. By following these rules, the lamp will be properly protected against water.
• If the light flickers, does not switch to higher power modes, or does not light up, it may be for one of the following reasons:
  
  • The battery is discharged - charge it or replace it.
  • The contacts inside the lamp are dirty - clean them with a cotton swab dipped in alcohol.
  • The head, body or back of the lamp is loose, tighten them.

Output: 2800lm
Max. durability: 42 hours
Aftersight: 380m
Number of modes: 6
Weight: 169g
Power supply: 1x 21700
Light source: Luminus SFT-70
Waterproof: IP68 (immersion 2 m)