Fenix ​​​​TK30R Rechargeable Laser Flashlight

The Fenix ​​TK30R rechargeable laser flashlight is one of the tactical flashlights with the longest range on offer. Its white laser light creates an extremely focused beam that is capable of illuminating up to 1500 meters and has a luminous flux of up to 500 lumens (ANSI). The light source is a white laser (class 1) with LEP (laser excited phosphor) technology, which is known for its use primarily in the automotive industry in the most luxurious vehicles. It is powered by one 21700 Li-ion battery with a capacity of 6000 mAh (included), which is charged via the USB-C connector directly in the flashlight. The charging socket is covered with a screw nut, so it is perfectly protected against water and dirt. The lamp is thus fully waterproof and dustproof according to the IP68 standard (tested under water at a depth of 2 meters). The TK30R has two levels of white light output with a runtime of almost 9 hours and also has a strobe flash. The flashlight uses a tactical switch with a rotary selector that allows you to choose between high and low. low power and locking. The lamp can also be switched directly into strobe mode. The light flux is concentrated in a narrow cone, which makes all the light fall on a specific target, and the lamp is thus ideal for hunting and illuminating distant targets.

All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

Fenix ​​TK30R flashlight parameters

• A white laser with LEP technology (laser excited phosphor) with a lifetime of 50,000 hours is used.
• Three lighting modes: 500 lumens (3.5 hours) -> 100 lumens (8.8 hours) -> Strobe 500 lumens.
• Special optics for a light cone with a range of 1500 meters (600,000 cd).
• Class 1 laser.
• Electronics with digital power regulation, protection against reverse insertion of batteries and protection against too deep battery discharge.
• It is powered by one 21700 6000 mAh Li-ion battery (included).
• Max. battery diameter 22.0 mm, max. Battery length 77.0 mm.
• Dimensions 18.4 cm (length) x 4 cm (head diameter) x 2.54 cm (body diameter).
• Intelligent protection against overheating.
• The lamp body is made of hardened aircraft aluminum type A6061-T6.
• Durable hard-to-scratch surface - Type III hard anodized.
• Impact-resistant from a fall from a height of 1 meter.
• Trapezoidal threads highly resistant to wear.
• Weight 250 grams (including battery).
• Waterproof and dustproof according to the IP68 standard (tested under water at a depth of 2 meters).
• Hardened ultra clear glass lens with anti-reflective coating.
• The battery stored between two springs - easily withstands recoil when used on a weapon.
• Tactical switch at the end of the flashlight (direct strobe function by holding the button).
• Rotary switch for selecting between high and low power and control lock.
• The flashlight comes with an ARB-L21-6000 battery, USB-C charging cable, wrist strap, belt holster, and spare O-ring.
• Optional accessories include: AER-05 cable switch, red or white traffic cone AOT-04, red filter AOF-L, white diffuser AOD-M, white diffuser AOD-04.
• The following accessories are also compatible with the flashlight: ALG-00 quick-release rail mount, ALG-15 quick-release rail mount, Fenix ​​ALG-16 M-LOK mount, Fenix ​​ALG-18 barrel mount, metal magnetic barrel mount, plastic magnetic barrel mount, flashlight mount for optics, metal optic mount.
• The lamp can also be purchased with a USB adapter for the mains and a USB adapter for the car.

Fenix ​​TK30R flashlight control

From the factory, there may be an insulating cap inside the lamp on the battery. Before first use, remove it from the battery.

Power on while the flashlight is unlocked: hold the tactical switch at the end of the flashlight for a silent momentary light on, release to turn the light off. Fully press the tactical switch to turn the light on/off permanently.

To turn on when the light is locked: turn the switch from the Lock position to the low or high power position to turn on the light.

Výber výkonu: otáčajte prepínačom na koncovke pre voľbu medzi polohami Zámok <-> Nízky <-> Vysoký a vyberte požadovaný výkon alebo uzamknutie (a zároveň vypnutie) svietidla.

Strobe activation: with the flashlight unlocked, fully press the tactical switch for 0.5 seconds to turn on the strobe. Briefly press the tactical switch again to return to constant lighting.

Indication of the state of charge of the batteries - for tactical reasons, the charge indicator is hidden under the protective nut of the charging connector, so it is necessary to unscrew the nut to check it. The lamp always indicates the battery charge status three seconds after switching on. Green indicates sufficient charge (100% - 85%), flashing green (85% - 50%), solid red (50% - 25%), and flashing red indicates a critically low battery (25% - 1%). If the battery is discharged, the lamp will gradually automatically switch to lower power modes.

Charging the lamp - Unscrew the protective nut under the head of the lamp and use the included USB-C cable to connect it to a computer, USB network adapter or USB car adapter (not included). Alternatively, any mobile phone charger with a USB-C connector can be used for charging. During charging, the indicator LED opposite the charging connector lights up red, after full charge it lights up green. Charging a fully discharged battery takes about 3.5 hours. The used Li-ion battery does not suffer from a memory effect, so the lamp can be recharged at any time. The lamp cannot be turned on during charging.

Intelligent protection against overheating - if the temperature of the lamp rises above 60 °C, it will automatically reduce the power in gradual steps.

 Warning

• Use only high-quality rechargeable Li-ion batteries of the 21700 type with protective electronics.
• Insert the battery with the positive pole facing the head of the lamp.
• If the protective rubber rings appear damaged after a long period of use, replace them. The rings must also be lubricated to prevent rubber erosion. By following these rules, the lamp will be properly protected against water.
• If the light flickers, does not switch to higher power modes, or does not light up, it may be for one of the following reasons:
  
  • The battery is almost empty - charge it or replace it.
  • The contacts inside the lamp are dirty - clean them with a cotton swab dipped in alcohol.
  • The head, body or back of the lamp is loose, tighten them.

Range: 1500m
Max. endurance: 8.8 hours
Output: 500lm
Number of modes: 3
Weight: 250g
Power supply: 1x 21700
Power supply: USB charging
Light source: LEP (laser excited phosphor)
Waterproof: IP68 (immersion 2 m)