Fenix BC06R rechargeable rear safety light
Fenix BC06R rechargeable rear flasher
The rechargeable Fenix BC06R red flasher brings two power levels - 10 and 30 lumens plus a brake light mode - 90 lumens. In both power levels, it has the function of fast flashing, slow flashing and constant lighting, in the lower level it also offers rotating lighting. Power is provided by a built-in lithium-polymer battery with a capacity of 560 mAh, which is charged via the USB-C connector directly in the lamp.The design of the attachment allows quick assembly and disassembly of the bicycle light without the use of tools. The sleeve fits a seat tube with a diameter of 25.4 to 31.6 mm. The package also includes a holder that can be used to attach the flasher to the under saddle skids (the distance between the skids must be between 39 and 50 mm).
In fast flashing mode with a power of 10 lumens, it lasts up to 24.5 hours. Fenix BC06R will provide you with safe lighting for night training, regular commuting to work and endurance races.
All lamp parameters (luminous flux, battery operation time, waterproofing, and afterglow) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.
A total of seven power modes: 30 lm (5.5 h) -> slow flashing 30 lm (5.5 h) -> fast flashing 30 lm (8 h) -> 10 lm (12.5 h) -> slow flashing 10 lm (14.5 h) - > fast flashing 10 lm (24.5 h) -> rotating light 10 lm (22 h).
It is possible to purchase a USB adapter for the mains and a USB adapter for the car, a USB adapter supporting fast charging and a colored USB-C cable.
Using a bicycle light
To turn it on or off, hold down the button on the lamp for about 0.5 seconds. The lamp is always switched on in the last used mode, except for the brake light 90 lm. You can switch power modes at any time during operation by briefly pressing the button (they are cyclically switched in the order low 10 lm - slow flashing 10 lm - fast flashing 10 lm - high 30 lm - slow flashing 30 lm - fast flashing 30 lm - rotating light 10 lm).Brake light function - if there is a sudden change in speed when the light is on, the lamp automatically activates the 90 lumen brake light. After two seconds, the light will automatically return to the previous lighting mode.
Battery capacity indication - with the lamp off, press the button briefly once, then the backlight of the button lights up for five seconds. Steady green light means the battery is more than 85% charged, green flashing means a charge of about 50-85%, red light means a charge of about 25-50% and red flashing means the battery is almost empty (less than 25%).
Low battery warning - if the battery voltage drops below 3.0 V, the lamp will reduce the brightness to a lower level and the LED indicator in the button will start flashing red to remind you of the need to recharge.
Charging
- Unfold the rubber cover of the USB-C connector on the back of the lamp and use the included cable to connect it to a computer, power bank, network USB adapter or USB car adapter. Any mobile phone charger with a USB-C connector can also be used for charging.
- While charging, the button lights up red, after full charge it lights up green.
- Charging time is approx. 1.5 hours. The used Li-pol battery does not suffer from a memory effect, so the lamp can be recharged at any time.
- After charging and removing the power cable, do not forget to seal the cover of the USB connector.
Warning
- Do not disassemble the sealed parts yourself, this will void the warranty.
- If the flashlight does not switch to a higher mode or does not light up, it may be because the battery is discharged - charge it.
|
Slightly raised optics create a wide light cone visible at an angle of 270°
|
|
Effective warning distance of the flasher reaches a distance of 100 meters
|
|
Uses a red Cree XP-E2 LED with a lifespan of 50,000 hours
|
|
Lamp has a built-in Li-pol battery with a capacity of 560 mAh
|
|
Brake light function detects a sudden change in speed and increases the output to 90 lumens for 2 seconds
|
|
Indication of the state of battery charge
|
|
Warning of discharged battery, protection against overcharging and complete discharge of the battery
|
|
Lamp made of durable plastic
|
|
Impact-resistant from a fall from a height of 1.5 meters
|
|
Rubberized construction of the holder sleeve ensures a firm and secure fit
|
|
Waterproof and dustproof according to the IP66 standard (spraying with strong streams of water from all directions)
|
| Power supply type | USB-C |
| Battery type | rechargeable |
| Number of modes | 8 |
| Power | 90 lm |
| Max operating time | 24.5 hours |
| Reach | 100 m |
| Weight | 44.5 g |
| Power supply | Internal accumulator |
| Light source | Cree XP-E2 |
| Waterproof | IP66 (heavy rain) |
| Dimensions | 3.8 x 3.8 x 3.8 cm (without sleeve and without holder) |
| Weight | 44.5 g (including battery) |
| Package contents | lamp, clamping rubber with holder for mounting on the seat post, holder for mounting on the rails under the saddle, 2x plastic zip ties, USB-C cable |
| product ID | 311057 |
All the answers to questions about delivery, payment, security, returns, warranty and much else.
