Sram adapter from PressFit 30 to BSA thread 68/73 mm
Sram reduction from a frame with a Press Fit 30 center with a diameter of 46 mm for a BSA thread.
Composite material, the two parts are screwed together.
Technical designation: 00.6415.049.010
Purpose: For centers PF30 - 46mm
| product ID | 6192 |
Je to použiteľné pre Shimano ultegra 8000 kľuky (stredovú osku)?
Dobrý deň,
Áno, toto je len adaptér do rámu a do adaptéra bude eštep otrebné dokúpiť stredové zloženie - vo Vašom prípade BSA pre od Hollowtech II
All the answers to questions about delivery, payment, security, returns, warranty and much else.

OK.OK.OK
Translate by GoogleShow the originalin addition to the fact that it is too expensive from the point of view of other competing products, after pressing it into the frame, I also had to tighten the BSA screw, because the shimano bowls could not even be turned half way into it with your fingers, and if you consider that I was putting it in a carbon frame, it was a pure risk turn it there with a key ..... they have a better solution from the mortop directly with the bearings, after pressing, just push the axle and that's it.
Automatically translated
tak ale to si robil zle - v tomto pripade sa maju najskor misky utiahnut do adaptera a az potom lisovat takyto komplet do ramu. Vyrobca to uvadza jasne.
Translate by GoogleShow the originalhttps://sram-cdn-pull-zone-gsdesign.netdna-ssl.com/cdn/farfuture/_PlwYDAo3-UuOMxE4sEx7WPi-Jkapm4CI4xkIRIzfLg/mtime:1372788169/sites/default/files/techdocs/95-6415-007-000_rev_c_gxp30_bb_adapter.pdf