Fenix E01 V2.0 flashlight, 100 lm

The second generation of the popular Fenix E01 V2.0 mini flashlight offers three performance modes with a luminous flux of up to 100 lumens (ANSI). Thanks to its negligible dimensions, it is an ideal representative of the EDC (Every Day Carry) category, it can be carried with you at all times, either in your pocket, on your keys or in your wallet. The flashlight is not much bigger than the micro-pencil AAA battery from which it is powered. It goes without saying that the high quality of the design, durability and waterproofness are essential. The ultra-thin collimator creates a wide light cone with an afterglow of up to 35 meters. This flashlight is destined by its properties to serve as a small, reliable companion that is always close at hand. You will always be happy with this useful gift.

All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

Fenix E01 V2.0 flashlight parameters

• The powerful Luminus SST-20 LED with a lifespan of 50,000 hours is used.
• Three power levels:
  
  • measured with rechargeable NiMH batteries: 100 lumens (50 minutes) -> 25 lumens (4.5 hours) -> 5 lumens (23 hours).
  • measured with disposable alkaline battery: 100 lumens (50 minutes) -> 25 lumens (4.8 hours) -> 5 lumens (25 hours).
• Uses only one micropen battery (type AAA - alkaline, lithium or rechargeable NiMH). These batteries are cheap and widely available.
• Energizer L92 lithium micropencil batteries (especially suitable for extreme temperature conditions) will provide the longest duration.
• The endurance times are measured with a rechargeable NiMH battery with a capacity of 750mAh and the included alkaline disposable battery.
• Supported battery voltage 0.9-1.7V.
• Dimensions 6.65 cm (length) x 1.5 cm (head diameter) x 1.4 cm (body diameter).
• Weight 13 grams (without battery).
• Wide light cone with an afterglow of 35 meters (304 cd).
• Made of aircraft hardened aluminum. Durable surface - Type III hard anodized.
• Impact-resistant from a fall from a height of 1 meter.
• Waterproof and dustproof according to the IP68 standard (tested under water at a depth of 2 meters).
• Reliable rotary switch.
• The package includes a metal ring for hanging on keys, a spare sealing o-ring and a micro-pencil alkaline battery.

The use

To turn on the lamp, point the reflector away from you and turn the reflector counterclockwise (tightening the head). Turning it in the opposite direction turns the flashlight off again (head release). To change the intensity of brightness, the lamp must be quickly switched off and on again. This switches the luminaire to the next level of output power. If you leave the light off for longer than 1.5 seconds, it will return to the lowest lighting mode (5 lumens).

Protection against overheating - during longer operation at the highest mode, the lamp can reduce power to reach the optimal temperature.

Warning

• Do not disassemble the sealed part in the lamp head yourself, this will void the warranty.
• Use only high-quality micro-pencil batteries to avoid damage to the lamp, for example due to leakage of substances from the battery.
• Remove the batteries from the lamp if you are not going to use it for a long time or if the battery is already discharged.
• Insert the battery with the positive pole towards the lamp head.
• If the protective rubber rings appear damaged after a long period of use, replace them. The rings must also be lubricated to prevent rubber erosion. By following these rules, the lamp will be properly protected against water.
• If the lamp flashes or does not light up, it may be for one of the following reasons:
  
  • Batteries are almost empty - replace them.
  • The contacts inside the light are clogged - clean them with a cotton swab dipped in alcohol.

Afterlight: 35 m
Max endurance: 25 hours
Output: 100 lm
Number of modes: 3
Weight: 13 g
Power supply: 1x AAA
Light source: Luminus SST-20
Waterproof: IP68 (immersion 2 m)