Shimano Deore FC-M5100-2 cranks, 2x11, 36/26T
Shimano Deore FC-M5100-2 cranks
Deore cranks with a fixed axis designed for 11-speed transmission systems.| Groupset | Shimano Deore |
| Gears | 2x11 |
| Crank length | 170 mm, 175 mm |
| Chain line | 48.8mm |
| Material | aluminium |
| Spacing | 96 mm / 64 mm |
| Frame width | 68 / 73 mm |
| Number of teeth | 36/26T |
| Q-factor | 178.5 mm |
| For the width of the rear structure | 135 mm / 142 mm |
| Weight | 850g (170mm) |
| product ID | 111613 |
Hello. I changed the bike from 3x10 to 1x11. The current cranks I would like to replace are Fc M770, center bearings are BB71-41A. The rear spacing should be 135mm, the bike is a Giant Athem 29er from 2010 I think. The chain is straight at approx. 8/9 gear and when pulling backwards the top two or three fall off, I would like to center it a little more, improve the chain line. If I read correctly, my current cranks are 50mm, but I'm not 100% sure on that figure.
This one is 48.8mm, but if I go with the fact that I immediately change to 1x11, I'm probably back to 50mm, so I didn't help myself, but I didn't make it worse either. Could you please advise me if I'm reading it correctly, or if these are suitable cranks or would another type be better for me?
Thanks!
Dobrý deň,
všeobecne pri bicykloch so 135 mm nábojom toho veľa nevymyslíte, pri 1x prevodových systémoch tam bude vždy väčšie kríženie. Teoreticky by to šlo upraviť aj podložkami pod prevodníkom + dlhšie skrutky, ale je to také home-made riešenie..
Pri výmene za tieto kľuky si nepolepšíte, bude to cca. rovnaké.
Dobrý deň.
Prosím vás pekne, takúto otázku mám :
Jazdím pohon 2x11 (38/28 x 11-42). Ak by som bol stavom kľúk donútený prejsť na kľuky 36/26, stačí reťaz skrátiť o 2 články, alebo ju môžem nehať na pôvodnej dĺžke ( 112čl.) ???
Ďakujem.
Dobrý deň,
vo všeobecnosti môžete ponechať aj pôvodnú dĺžku reťaze, rozdiel 2 zubov pokryje ramienko na prehadzovačke svojím napnutím. Pri ďalšej výmene reťaze môžete novú reťaz skrátiť.
Hello. Is it also suitable for using 2x10? I suppose so, but just to be sure...
What is the difference between this version and the B2 version?
Dobrý deň,
Nemal by byť problém s použitím pre 2x10.
B2 verzia je určená pre Boost rámy.
Ahoj, chcem sa opytat, ci maju kluky 24mm pevnu osku na HT II, lebo som sa to tu nikde nedocital... Dik za odpoved...
Dobrý deň,
Áno stredová os je Hollowtech II
Hello. Can these cranks be used for a single gear, with a change of gear 30,32, or oval? Well thank you
Automatically translated
Dobrý deň,
ak nájdete prevodník ktorý má rovnakú rozteč ako veľký prevodník tak áno.
Hello, I would like to ask if they are compatible with the MT-800 center
Automatically translated
Dobrý deň,
Áno kľuky budú kompatibilné.
Good day,
Can these cranks be swapped for FC-MT500-B 36.26 2x10?
Dobry den,
kolko rychlostny prevodovy system pouzivate? Oska kluk sadne, je rovnaka, prevodniky su vsak v pripade FC-MT500 urcene pre 10-rychlostne retaze, pri tychto FC-M5100 su uzsie a urcene primarne pre 11-rychlostne retaze.
Zdravím,
Používam 2x10, takže vhodnejší bude asi FC-M4100.
Zdravím, bolo by mozne objednat aj 34/24. Dakujem.
Dobrý deň,
Tieto kľuky sa vyrábajú jedine v prevedení 36/26
WARNING
For installation, adjustment and replacement information that is not found in the user's manual, please consult the place of purchase or a distributor. A dealer's manual intended for professional and experienced bicycle mechanics is available on our website (https://si.shimano.com).
For safety, be sure to read this “user's manual” thoroughly before use, follow it for correct use, and save it so that you can refer back to it at any time.
The following instructions must be always followed in order to prevent personal injury and physical damage to equipment and the surroundings. The instructions are classified according to the degree of danger or damage that may occur if the product is used incorrectly.
DANGER – Failure to follow the instructions will result in death or serious injury.
WARNING – Failure to follow the instructions could result in death or serious injury.
CAUTION – Failure to follow the instructions could result in personal injury, or physical damage to equipment and surroundings.
WARNING:
Do not disassemble or modify the product. This may cause the product to not operate correctly, and you may fall unexpectedly and be seriously injured.
Before riding the bicycle, check that the crank arms are not cracked. If there are cracks, the crank arm may break and you may fall off the bicycle.
Be careful to keep your clothing from getting caught in the chain during riding. If your clothing gets caught, you may fall off the bicycle.
CAUTION:
Be careful not to touch the teeth of the sprockets. There is a danger of injury.
All the answers to questions about delivery, payment, security, returns, warranty and much else.

lacnejsia alternativa k XC sade, rozdiel nepoznam, jedine vaha, super cena
Translate by GoogleShow the originalI rate the quality of the product very positively. I am very satisfied.
Automatically translated
Čo dodať. Shimano deore hovorí za srba samé
Translate by GoogleShow the original
Jó hajtómű, tartós darab.
Translate by GoogleShow the original
brutalne vela vydrzi
Translate by GoogleShow the original
Ok
Translate by GoogleShow the original
Spokojnosť, dobra cena
Translate by GoogleShow the original