Fenix CL09 flashlight
The Fenix CL09 flashlight is equipped with a three-color LED with white, red and green light. Thanks to its compact dimensions and excellent ratio of size and performance, it is suitable for EDC and can be carried basically anywhere. Clip it to your keys, backpack or use it as a candle. Thanks to the flash modes, it can also be used as a signaling and position light.
The lamp is not much bigger than the RCR123A battery with USB from which it is powered and which is included in the package. The battery can be recharged via the built-in micro USB connector, e.g. mobile phone charger. It goes without saying that the high quality of the design, durability and waterproofness are essential. Due to its properties, the lamp is destined to serve as an ideal small and reliable companion that is always close at hand. It is very suitable for hiking and camping.
All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.
Fenix CL09 mini lantern parameters:
- A three-color LED (Light Emitting Diode) with a lifespan of up to 100,000 hours is used.
- Seven lighting modes:
- measured with the included RCR123A 700 mAh battery: 200 lumens white (2.6 hours) -> 80 lumens white (5.6 hours) -> 30 lumens white (19.3 hours) -> 1 lumen white (90 hours) -> 5 lumens red (30 hours) -> 5 lumens green (48 hours) -> 5 lumens red flashing
- measured with CR123A disposable battery: 200 lumens white (6 hours) -> 80 lumens white (19 hours) -> 30 lumens white (36 hours) -> 1 lumen white (150 hours) -> 5 lumens red (48 hours) - > 5 lumens green (76 hours) -> 5 lumens red flashing
- Uses only one Fenix RCR132A USB Li-ion battery. The package includes a variant with a built-in micro USB input.
- Alternatively, a disposable CR123A battery can be used.
- Dimensions 7.85 cm (length) x 2.2 cm (diameter).
- Omnidirectional light cone, afterglow up to 10 meters (15.9 cd).
- Two color options: black and gray.
- Made of aircraft hardened aluminum and durable plastic.
- Protection against reverse insertion of batteries (reverse polarity).
- Durable surface - Type III hard anodized.
- Weight 31.5 grams (without battery).
- Waterproof according to the IP68 standard (tested under water at a depth of 2 meters for 30 minutes).
- Reliable rotary switch.
- Able to stand on its own on a flat place and serve as a candle.
- The package includes a key ring, replacement sealing o-ring and one Fenix ARB-L16-700U 700 mAh battery.
Product reviews
In the CL09 miniature lantern, Milan Gigel discovers a valuable and practical tool on the pages of doprirody.prakticky.sk. "It can surprise with its light output, versatility of lighting modes and durability."
The use:
Turn the end of the lantern clockwise to turn it on. Turning it in the opposite direction turns off the lantern again. To change the lighting mode, it is necessary to quickly turn off the lamp from the on state and turn it on again. This switches the modes in the order Low -> Medium -> High -> Turbo -> Red -> Red flashing -> Green. If you leave the light off for longer than 1 second, it will return to the lowest light mode (1 lumen).
Notice:
Do not disassemble the sealed parts yourself, this will void the warranty. Remove the batteries from the lamp if it will not be used for a long time or if the battery is already discharged. This will prevent the lamp from being damaged by leaking discharged batteries. If the protective rubber rings appear damaged after a long period of use, replace them. The rings must also be lubricated to prevent rubber erosion. By following these rules, the lamp will be properly protected against water. If the lamp flashes, does not switch to higher power modes, or does not light up, it may be for one of the following reasons:
Batteries are almost empty - replace them.
The contacts inside the lamp are dirty - clean them with a cotton swab dipped in alcohol.
Warranty:
Five-year warranty for the lamp and two years for the battery.
Max endurance: 150 hours
Max power: 200lm
Number of modes: 7
Weight: 50g
Afterlight: 10m
Power supply: 1x CR123A
Power supply: 1x RCR123A
Light source: SMD diodes
Waterproof: IP68 (immersion 2 m)
product ID | 131812 |

There are currently no reviews