SRAM adapter from PressFit 30 to BSA thread 68/73 mm
Sram adapter from Press Fit 30 frame with 46mm diameter to BSA thread.
Composite material, two parts screw together.
Technical designation: 00.6415.049.010
Designation: For PF30 - 46mm bottom brackets
| product ID | 6192 |
Je to použiteľné pre Shimano ultegra 8000 kľuky (stredovú osku)?
Dobrý deň,
Áno, toto je len adaptér do rámu a do adaptéra bude eštep otrebné dokúpiť stredové zloženie - vo Vašom prípade BSA pre od Hollowtech II
All the answers to questions about delivery, payment, security, returns, warranty and much else.


































































OK.OK.OK
Translate by GoogleShow the originalin addition to the fact that it is too expensive from the point of view of other competing products, after pressing it into the frame, I also had to tighten the BSA screw, because the shimano bowls could not even be turned half way into it with your fingers, and if you consider that I was putting it in a carbon frame, it was a pure risk turn it there with a key ..... they have a better solution from the mortop directly with the bearings, after pressing, just push the axle and that's it.
okrem toho ze je to predrazene z pohladu inych konkurencnych produktov po zalisovani do ramu som musel dat este aj precistit BSA zavit lebo shimano misky nesli do neho zatocit prstami ani do polovice a ked si zoberiete ze som to daval do karbonoveho ramu tak to bol cisty risk to tam zatacat klucom .....lepsie riesenie maju od mortopu priamo aj z loziskami , po zalisovani uz iba nasunut osku a je to.
Show translationAutomatically translated
tak ale to si robil zle - v tomto pripade sa maju najskor misky utiahnut do adaptera a az potom lisovat takyto komplet do ramu. Vyrobca to uvadza jasne.
Translate by GoogleShow the originalhttps://sram-cdn-pull-zone-gsdesign.netdna-ssl.com/cdn/farfuture/_PlwYDAo3-UuOMxE4sEx7WPi-Jkapm4CI4xkIRIzfLg/mtime:1372788169/sites/default/files/techdocs/95-6415-007-000_rev_c_gxp30_bb_adapter.pdf