Fenix TK35 UE V2.0 LED lamp (5000 lumens)

The fourth generation of the tactical flashlight with the designation Fenix TK35 Ultimate Edition V2.0 brings a luminous flux of up to 5000 lumens (ANSI) and a wide, continuous cone with an afterglow of up to 400 meters. It also achieves these parameters thanks to three high-performance Luminus SST40 LEDs. It is recommended to power the lamp with two 18650 li-ion batteries or four CR123A batteries. In an emergency, two CR123A batteries or only one 18650 battery can be used. However, the highest modes will not be available with them. The lamp is equipped with a rotary control, which can be used to lock the control or choose one of the two modes of use. In tactical mode, the light can be turned on to 3500 lumen mode or to a stroboscope with the same power. In service mode, it is possible to choose between five lighting modes (30 - 350 - 800 - 2000 - 5000 lumens) and a strobe. In the lowest mode, it can shine for up to 85 hours. Thanks to the arrangement of the batteries next to each other, the lamp is surprisingly short and fits perfectly in the hand. The precise and waterproof design according to the IP68 standard predestines this tactical light primarily for demanding outdoor conditions. It will be great for security forces in search and rescue operations, but also for hunting and other outdoor activities.

All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

Parameters

• Three high-performance Lumius SST40 LEDs with a lifespan of 50,000 hours are used.
• A total of eight performance modes:
  
  • Tactical mode: 3500 lumens (1.8 hours) -> strobe 3500 lumens
  • Duty mode: 5000 lumens (1.7 hours) -> 2000 lumens (2 hours) -> 800 lumens (4 hours) -> 350 lumens (13.7 hours) -> 30 lumens (85 hours) -> strobe 3500 lumens
• Duration times are measured with rechargeable 18650 li-ion batteries with a capacity of 3000mAh (not included in the package).
• It is also possible to use 4 pieces (2 pieces in an emergency) of disposable lithium CR123/CR123A batteries or 1x 18650 li-ion battery for power supply. However, the highest modes will not be available with them.
• Textured reflector for a smooth wide cone with an afterglow of up to 400 meters (40000 cd).
• Digitally regulated for constant brightness.
• The lamp has a memory and will always turn on in the last set mode (does not apply to the strobe).
• Switch for quick strobe activation.
• Protection against accidentally inserting the battery upside down (reverse polarity).
• Made of aircraft hardened aluminum type A6061-T6.
• Trapezoidal threads highly resistant to wear.
• Durable hard-to-scratch surface - Type III hard anodized.
• Impact resistant to a drop from a height of 1 meter.
• Waterproof according to the IP68 standard (up to a depth of 2 meters for 30 minutes).
• Tactical switch at the end of the light (momentary on / off function).
• Dimensions 14.3 cm (length) x 4.3 (reflector diameter).
• Weight 202 grams (without batteries).
• Hardened ultra clear glass lens with anti-reflective coating.
• A hand strap, a case, and a spare o-ring are included with the lamp.
• Batteries are not included in the package.

The use

The lamp offers three modes. It switches between individual modes with a rotary wheel, which is located at the end of the light.

Service mode - to turn on, press the main switch of the lamp. Then, with further short presses of the smaller button (located in the middle of the rotary controller), the modes are cyclically changed in the order of 30 - 350 - 800 - 2000 - 5000 lumens. To activate the strobe, hold down the smaller button for about 1 second. To switch back to constant light, press the smaller button again or turn the lamp off and on. In service mode, the lamp remembers the last set mode, except for the stroboscope.

Tactical mode - press the main switch to turn the light on and off. Only 3500 lumen mode is available in tactical mode. If the light is on in tactical mode, you activate the strobe by pressing the smaller button. Press it again to deactivate the strobe.

Locking - the third position on the rotary selector locks the lamp and it cannot be turned on - suitable, for example, when transporting in luggage. The lamp can be locked in the off and on state, locking turns the lamp off at the same time. Locking is signaled by permanent green-red flashing of the indicator LEDs in the button, which can help, for example, to find a lamp in the dark. The lock indication can be turned off or on again by holding down the smaller button for 3 seconds.

Turning on the lamp directly into the stroboscopic mode - press and hold the smaller switch on the rotary button, the stroboscope will be active for the duration of its holding.

Intelligent protection against overheating - after exceeding the temperature of 60 °C, the lamp will automatically gradually reduce power, after cooling below this limit, the highest modes will be available again.

Battery capacity indication - after turning on the lamp, the colored LED indicator in the switch lights up for 3 seconds. If the indicator light is green, the battery is charged to more than 85%. Green flashing means 50-85% capacity. If it lights up red, the battery is charged to 25-50%. Blinking red means there is less than 20% battery capacity left. The indication works correctly only with the use of Fenix 18650 batteries.

Warning of discharged batteries - the lamp will gradually automatically switch to the lowest power mode and the indicator diode in the switch button will start flashing red.

Warning

• Do not disassemble the sealed parts of the lamp yourself, this will void the warranty.
• Never use different discharged batteries or batteries with different capacities.
• Use only high-quality batteries and accumulators to avoid damage to the lamp, for example due to leakage of substances from the battery.
• If the protective rubber rings appear damaged after a long period of use, replace them. The rings must also be lubricated to prevent rubber erosion. By following these rules, the lamp will be properly protected against water.
• If the light flickers, does not switch to higher power modes, or does not light up, it may be for one of the following reasons:
  • Batteries are almost empty - replace them.
  • The contacts inside the lamp or the battery holder are dirty - clean them with a cotton swab dipped in alcohol.
  • The lamp body is loose - add lubricant to the sealing rings and tighten.

Warranty

Five-year warranty.

Output: 5000lm
Max. duration: 85 hours
Aftersight: 400m
Number of modes: 8
Weight: 202g
Power supply: 2x 18650
Power supply: 4x CR123A
Light source: Luminus SST-40
Waterproof: IP68 (immersion 2 m)