Fenix GL19R V2.0 weapon rechargeable flashlight, black

Fenix GL19R V2.0 Weapon Rechargeable Flashlight

The Fenix GL19R V2.0 rechargeable pistol flashlight is designed specifically for use on short firearms. It offers a top-tier light output of 1200 ANSI lumens with a beam throw of up to 420 meters. The flashlight is powered by a single Fenix 18350 1100 mAh Li-ion battery, which is recharged directly in the flashlight via a USB-C connector on its side and is included in the package. The simplified operation of the flashlight is ambidextrous (for right-handed and left-handed users).

The GL19R V2.0 model comes with three switch lengths (universal - factory installed, shortened, and extended versions), which can also be combined (use a different switch length on each side of the flashlight according to personal preferences). Mounting on the weapon rail is simple and requires no tools - the flashlight slides onto the weapon rail and is secured by a lever. It can be attached to Picatinny MIL-STD-1913 and GLOCK standard weapon rails (may not fit slimline category weapons, e.g., Glock 30 model). It fits SR Police service weapons (CZ 75D). The flashlight is therefore suitable for professionals, sports and hobby shooters, and airsoft.

The package includes a Fenix ARB-L18-1100 battery, two sets of spare switch pads (the third set is already installed on the flashlight from the factory), a USB-C charging cable, an Allen wrench, a mounting plate for the Picatinny rail (the plate for GLOCK is already pre-installed on the flashlight from the factory), a spare USB connector cover, a spare o-ring, and a manual.

Fenix GL19R V2.0 Flashlight Operation

From the factory, there may be an insulating cap inside the flashlight on the battery. Remove it from the battery before first use.
For momentary-on, push the tail switch to the upper position and hold. When released, the switch returns to the middle position and the flashlight turns off.

For constant-on, push the tail switch to the lower position. Pushing it back to the middle position turns the flashlight off.
Charging the flashlight - flip open the rubber cover of the charging connector and connect it to a computer, mains USB adapter, or car USB adapter (not included) using the provided USB-C cable. A mobile phone charger with a USB-C connector can also be used for charging. During charging, the indicator LED on the side of the flashlight glows red, and glows green when fully charged. Charging a fully depleted battery takes approximately 2 hours. The Li-ion battery used does not suffer from a memory effect, so the flashlight can be recharged at any time.

Battery replacement - unscrew the flashlight head and insert the battery with the positive pole facing outwards (towards the head). Then, fully tighten the head again.

Intelligent overheat protection - if the flashlight temperature exceeds 60 °C, the output will automatically decrease. Once the temperature drops below 55 °C, the output will gradually increase again.

Notice

• Use only high-quality rechargeable batteries to avoid damaging the flashlight, for example, due to battery leakage.
• When using the flashlight on a weapon, observe all safety regulations.
• Insert batteries with the positive pole facing the flashlight head.
• If the flashlight is blinking, shining at low power, or not turning on, it may be due to one of the following reasons:
  • The battery is depleted - replace or charge it.
  • The contacts inside the flashlight are dirty - clean them with a cotton swab dipped in alcohol.