Shimano STEPS BM-EN600 flashlight holder for frame, without lock, with cable 300 mm
Flashlight holder STEPS BT-EN600. Compatible with second generation SHIMANO STEPS batteries BT-EN604, BT-EN605, BT-EN606. It is intended for mounting on the lower frame tube. Compatible with Axa, Abus and Trelock locks (the lock is not part of the package). Cable: black, 300mm long.
| product ID | 207392 |
WARNING
For information on installation, adjustment and replacement of the products which are not found in the user's manual, contact the place of purchase or a distributor. A dealer's manual for professional and experienced bicycle mechanics is available on our website (https://si.shimano.com).
For safety, be sure to read this "user's manual" thoroughly before use, follow it for correct use, and keep it in a safe place for future reference.
The following instructions should always be followed in order to prevent personal injury, damage to equipment or damage to the surroundings. The instructions are classified according to the degree of danger or damage which may occur if the product is used incorrectly.
DANGER - Failure to follow the instructions will result in death or serious injury.
WARNING - Failure to follow the instructions could result in death or serious injury.
CAUTION - Failure to follow the instructions could result in personal injury, or physical damage to equipment and surroundings.
DANGER
Handling the battery
- Be sure to use the specified battery charger and observe the specified charging conditions when charging. If this is not observed, overheating, bursting, or ignition may occur.
- Do not leave the battery near heat sources such as heaters. Otherwise, the battery may burst or ignite.
- Do not heat the battery or throw it into a fire. Otherwise, the battery may burst or ignite.
- Do not deform, modify, or disassemble the battery, and do not directly apply solder to the battery terminals. Otherwise, the battery may leak, overheat, burst, or ignite.
- Do not short-circuit the terminals with metallic objects. Otherwise, the battery may short-circuit or overheat, resulting in burns or other injuries.
- Do not carry or store the battery together with metallic objects such as necklaces or hairpins. Otherwise, the battery may short-circuit or overheat, resulting in burns or other injuries.
- Do not immerse the battery in fresh or salt water, and do not allow the battery terminals to get wet. Otherwise, the battery may overheat, burst, or ignite.
- Do not subject the battery to strong impacts or throw it. Otherwise, the battery may overheat, burst, or ignite.
- The following points should be observed in the event of a fire involving the battery:
If possible, carefully keep other batteries away from the fire.
Evacuate all persons from the immediate area of the fire.
Extinguish the fire with large amounts of cold water (at least 10 times the weight of the battery blocks).
Handling the battery charger
- Do not disassemble or modify the battery charger. Failure to observe this may result in electric shock or injury.
- Be sure to use the specified battery and charger combination and observe the specified charging conditions when charging. Only charge rechargeable batteries. Otherwise, overheating, bursting, or ignition may occur.
- If the battery is not fully charged after 2 hours have elapsed after the specified charging time, immediately disconnect the battery from the electrical outlet and contact the place of purchase. Otherwise, overheating, bursting, or ignition may occur.
Refer to "Specified charging time."
- Do not allow the battery charger to get wet. If the battery charger gets wet or water gets inside it, this may result in fire, overheating, or electric shock.
- Do not use it while it is wet, and do not touch or hold it with wet hands. Electric shock may result.
- Do not cover the battery charger with cloths or other similar materials during use. Otherwise, heat may build up, deforming the case, or resulting in fire, ignition, or overheating.
- Only use the battery charger at the specified power supply voltage. If the power supply voltage is anything other than the specified value, fire, explosion, smoking, overheating, electric shock, or burns may result.
WARNING:
Handling the battery
- Use the product under the supervision of a person responsible for safety and only as instructed. Do not allow anyone (including children) with reduced physical, sensory or mental abilities, or persons without experience or knowledge to use the product. Do not allow children to play near the product.
- Keep out of reach of children.
- If liquid leaking from the battery gets into the eyes, immediately rinse the affected area thoroughly with clean drinking water (tap water) without rubbing the eyes, and seek immediate medical attention. Failure to do so may result in the battery liquid damaging your eyes.
- If leaking liquid gets onto your skin or clothing, immediately wash it off with clean water (wash for at least 15 minutes). The leaking liquid may damage your skin.
- Medical attention is required if symptoms occur due to accidental ingestion of battery liquid, contact with skin or eyes, or inhalation of combustion products from the battery.
- If you accidentally inhale fumes or vapors, immediately move to a place where there is fresh air, keep warm and quiet, and seek expert medical advice if necessary.
- Do not use the battery outside of the specified operating temperature range. If the battery is used or stored at temperatures outside of these ranges, fire, battery damage, or problems during operation may occur.
1. During discharging: -10 – 50 °C
2. During charging: 0 – 40 °C
Temperatures above 60 °C may cause leakage and bursting of the battery.
- Do not use the battery if there are noticeable scratches or other external damage. Failure to observe this may result in bursting, overheating, or problems during operation.
- Do not use products with broken seals. Immediately hand them in for appropriate recycling. (The screw heads on the cover are sealed with adhesive or a cover.)
- Do not use the battery if it exhibits leakage, discoloration, deformation, or other abnormalities. Failure to observe this may result in bursting, overheating, or problems during operation.
- Batteries must not come into contact with solvents (i.e. thinners, alcohol, oil or anti-corrosion agents) or chemicals that affect the surface (i.e. cleaning agents).
Handling the battery charger
- When connecting or disconnecting the cable, hold it by the mains plug. Failure to do so may result in fire or electric shock.
- If any of the following symptoms occur, stop using the device and consult the place of purchase. Fire or electric shock may result.
If pungent smoke comes out of the mains plug or the plug gets hot.
There is a poor connection inside the mains plug.
- During thunderstorms, do not touch the metal parts of the mains plug or AC adapter. Electric shock may result from lightning strikes.
- Do not overload the electrical outlet with appliances that exceed the outlet's rated capacity, and only use a 100 – 240 V AC power supply electrical outlet. If the electrical outlet is overloaded by connecting a large number of appliances using adapters, this may cause overheating resulting in fire.
- Do not damage the power cord or mains plug. (Do not damage it, modify it, forcibly bend it, twist it, or stretch it; do not place it near hot objects, place heavy objects on it, or tie it tightly together.) If used in a damaged state, fire, electric shock, or short-circuiting may result.
- Do not use the battery charger in conjunction with commercially available electrical transformers designed for overseas use (travel converters). Doing so may cause damage to the battery charger.
- Always insert the mains plug all the way in. Failure to do so may result in fire.
- Do not insert or remove the plug when it is wet. Otherwise, electric shock may result. If water is leaking from the plug, thoroughly dry it before inserting the plug.
- Do not charge the battery in damp locations or areas with high humidity. (EC-E8004) Do not charge the battery in damp locations, areas with high humidity, or outdoors. (Battery charger other than EC-E8004) Fire, ignition, overheating, or electric shock may result.
- Do not move the bicycle while charging the battery when it is installed on the bicycle. The mains plug of the battery charger may become loose and may not be fully inserted into the electrical outlet, posing a fire hazard.
CAUTION
Handling the battery
- Do not leave the battery in a place exposed to direct sunlight, inside a vehicle on a hot day, or in other hot places. This may result in leakage of the battery liquid.
- Avoid large changes in temperature.
- Do not store this product near open flames or food.
- Store the battery in a dry location.
- Handle the components with both hands. Otherwise, the components may fall and break or cause injury.
- If an error occurs during charging or discharging of the battery, immediately stop using it and consult the user's manual. If you are unsure, contact the place of purchase or a distributor.
- Do not touch the battery for a long time when it is at a high temperature. This may cause low-temperature burns. Riding with a high assist level on hot days or charging the battery in direct sunlight may cause the surface temperature of the battery to exceed 60 °C (BT-E8036).
Handling the battery charger
- Periodically check the battery charger and adapter, paying particular attention to damage to the cord, plug, and casing. If the charger or adapter is damaged, do not use it until it has been repaired at the place of purchase or by a distributor.
- Use the product under the supervision of a person responsible for safety and only after receiving instructions regarding its use. Do not allow the product to be used by persons with reduced physical, sensory or mental abilities, inexperienced persons, or persons without the required knowledge. Do not allow children to play near the product.
- When cleaning, pull the mains plug out of the electrical outlet and the charging plug out of the battery. Failure to do so may result in electric shock.
- Do not touch the battery charger when it is at a high temperature. This may cause burns.
- Do not touch the battery charger for a long time when the temperature of the battery charger has increased. This may cause low-temperature burns.
- The temperature of the product may reach 40 to 70 °C during charging. However, this is normal.
- Before using the battery charger, read all instructions and warning markings on the battery charger, battery, and product using the battery
All the answers to questions about delivery, payment, security, returns, warranty and much else.

There are currently no reviews