Fenix ​​E03R V2.0 GE rechargeable lamp, nebula

Fenix ​​E03R V2.0 Gift Edition is the successor of the successful miniature rechargeable lamp that can be carried on keys or in a purse. Despite its minimal dimensions and weight of only 30 grams, it offers a high luminous flux of up to 500 lumens (ANSI). The light cone evenly illuminates a wide area up to a distance of 90 meters. It is powered by an integrated Li-pol battery with a capacity of 400 mAh, which is charged via a modern USB-C connector on the side of the lamp. There are a total of four white light modes and two red light modes with a maximum duration of up to 30 hours in the lowest mode. A unique novelty is the so-called Breathing light, a pulsating light around the switch button with a power of 1 lumen, which you can use for inconspicuous signaling or identification of the location of the lamp and even the set of keys. The lamp comes with a ring for hanging it on your keys, so you can easily carry it with you at all times. The battery charge status indicator in the button is also practical. You will always be happy with this useful gift.

All lamp parameters (luminous flux, battery operation time, waterproofing, impact resistance and afterglow) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

Fenix ​​E03R V2.0 lamp parameters

• Two white MATCH CA18 LEDs and a red Everlight 2835 LED are used. All with a lifespan of 50,000 hours.
• Four white light modes: 500 lumens (1.3 hours) -> 150 lumens (2 hours) -> 30 lumens (6.5 hours) -> 5 lumens ( 30 hours ).
• Two red light modes: 5 lumens -> red flashing (5 lumens).
• Pulsating light around the switch button with a power of 1 lumen ( Breathing light ).
• The lamp is powered by a built-in rechargeable lithium-polymer battery with a capacity of 400 mAh.
• Battery charge status indication in the button.
• Charging via a modern USB-C connector.
• Memory for the last set white light output mode.
• Intelligent protection against overheating.
• CNC milled aluminum alloy body with Type III hard anodized anti-scratch finish.
• Dimensions 5.25 cm (length) x 2.6 cm (width) x 1.3 cm (height).
• 90 meter afterglow (2082 cd).
• Weight 30 grams (including battery).
• Waterproof according to the IP66 standard (spraying with strong streams of water from all directions).
• Impact resistant to a fall from a height of 1 meter.
• The package includes a ring for hanging on keys and a charging USB-C cable.
• It is possible to purchase a USB-C cable, a colored USB-C cable or a reduction from micro-USB to USB-C.

The use

To turn on or off, hold down the side button for about 0.5 seconds. Hold the button for 1.2 seconds to turn on the red light. You can switch power modes at any time during operation by pressing the side button. To turn on the Breathing light, turn off the light and quickly press the button twice.

The control button can be locked so that it does not turn on by itself, e.g. when transported in luggage - to lock, turn off the light and hold the button for 3 seconds. The light will then flash twice to indicate locking. To unlock, hold the button again for 3 seconds.

Battery charge indication - press the button briefly once with the lamp off, which will light up the small diode in the button for three seconds. A green light indicates a battery charged to 100-85%, a green flashing 85-50%, a red light indicates a battery charged to 50-25%, and a red flashing indicates a battery charged to less than 25%.

Protection against overheating - if the temperature of the lamp exceeds 60°C, the output will be automatically reduced. As soon as the temperature drops below 60°C, it is possible to use the highest power again.

Warning of discharged batteries - the lamp will gradually automatically switch to the lowest power mode and the indicator diode in the switch button will start flashing red.

Charging

• Unfold the rubber cover of the USB-C connector and connect the lamp with a USB-C cable to a computer, USB network adapter or USB car adapter. Any mobile phone charger with a USB-C connector can also be used for charging.
• During charging, the indicator LED in the button lights up red, after full charge it lights up green.
• The charging time of a fully discharged battery takes approx. 2 hours.
• The Li-pol battery used does not suffer from a memory effect, so the lamp can be recharged at any time.
• Seal the USB connector cover thoroughly after each charge.

Warning

• Do not disassemble the sealed parts yourself, this will void the warranty.
• In a humid environment, make sure that the cover of the USB-C connector is properly seated in the lamp.
• If the lamp does not switch to higher power modes or does not light up, the battery is discharged - charge the lamp.

Max. duration: 30 hours
Output: 500lm
Number of modes: 6
Weight: 30g
Afterlight: 90m
Power supply: Internal accumulator
Light source: Everlight 2835
Light source: MATCH CA18
Waterproof: IP66 (heavy rain)