Fenix BC05R rechargeable flasher

The Fenix BC05R rechargeable red flasher delivers up to 10 lumens (ANSI). The power supply is a built-in lithium-polymer battery with a capacity of 240 mAh, which is charged via a USB-C type connector directly in the luminaire. The light source is three red LEDs visible from a distance of 200 meters. The weight of the lamp is negligible 19 grams. The package also includes a buckle, thanks to which the lamp can be attached to a backpack, clothes or a headband strap. It can therefore be used not only as a rear bicycle light, but also as a safety red light for running and hiking.

The design of the holder allows quick assembly and disassembly of the light from the bicycle without the use of tools. The sleeve fits on a seat tube with a diameter of 20 to 35 millimeters.

The Fenix BC05R offers a total of two steady light modes and two flash modes with up to 72 hours. Fenix bicycle lights will provide you with safe lighting for night training, regular commuting and endurance races.

All luminaire parameters (luminous flux, battery life, water resistance and afterglow) are measured in accordance with the ANSI / NEMA FL 1-2009 standard.

Fenix BC05R light parameters

• Three red LEDs with a lifespan of 50,000 light hours are used.
• A total of four power modes: 2 lumens (10 hours) - slow flashing 2 lumens (40 hours) - fast flashing 2 lumens (72 hours) - 10 lumens (1.8 hours).
• The lamp has a built-in Li-pol battery with a capacity of 240mAh.
• Charging via USB-C connector.
• Digitally controlled for constant brightness.
• Low battery warning, overcharge protection and full battery discharge.
• Battery charge status indication.
• Afterglow 6 meters, visible from a distance of up to 200 meters.
• The rubberized construction of the holder sleeve ensures a firm and secure grip.
• The lamp is made of impact-resistant plastic.
• Light dimensions: 5.1 cm x 2.2 cm x 2.1 cm.
• Light weight: 19 grams including battery.
• Waterproof and dustproof according to the IP66 standard (spraying with strong water jets from all directions).
• Package contents: lamp, clamping rubber, clip, USB-C cable.
• A micro-USB to USB-C adapter can be purchased to charge the flasher with a standard micro-USB cable.

The use

To switch on or off, hold down the button on the luminaire for approx. 0.5 seconds. You can switch the power modes at any time during operation by briefly pressing the button (they cycle cyclically in the order low - slow flashing - fast flashing - high).

Battery capacity indication - with the light off, briefly press the button once, then the button backlight will illuminate for five seconds. A steady green light indicates a more than 70% charged battery, a steady orange light indicates a charge of about 41-70%, a steady red light indicates a charge of about 10-40%, and a red flashing indicates a low battery (less than 10%).

Low battery warning - if the battery capacity drops below approx. 20%, the luminaire will automatically switch to lower power modes to ensure the longest possible endurance (the luminaire cannot then be switched to higher modes). If the battery is critically discharged, the button will flash red. In this case, we recommend charging the light as soon as possible so that the protective electronics built into the batteries do not switch off and thus go out.

Charging

• Open the rubber cover of the USB-C connector on the back of the lamp and connect it to a computer, power bank, USB mains adapter or USB car adapter using the enclosed cable. It is also possible to use any charger with a USB-C connector for charging.
• During charging, the button lights up red, when fully charged it lights up green.
• Charging time is about 1.5 hours. The used Li-pol battery does not suffer from the memory effect, so the light can be charged at any time.
• After charging and removing the power cord, be sure to seal the USB connector cover.
  

Warning:

• Do not disassemble the sealed parts of the luminaire yourself, as this will void the warranty.

• If the lamp flashes or does not light up, then the battery is flat. Charge him.

Warranty:

Statutory two-year warranty.

Number of modes: 4
Max power: 10lm
Max endurance: 72 hours
Afterglow: 6m
Weight: 19g
Power supply: Internal battery
Light source: SMD diodes
Water resistance: IP66 (heavy rain)