Professional lamp Fenix WF11E with ATEX/IEC certification for use in explosive environments. The lamp is powered by three AA batteries and provides a luminous flux of up to 200 lumens. The body of the lamp is made of antistatic plastic (polycarbonate RTP399 x 133887) with high resistance and impact resistance. In addition, the lamp is equipped with a fixed clip with an integrated magnet and a magnetic end, so it can be attached to anything iron. The lamp is mainly intended for firefighters and rescuers, and is also suitable as a work lamp for industrial establishments such as chemical plants, refineries, textile mills, paper mills, mills and other establishments with an increased risk of explosive gases and dust.
Certificates:
Usable in zones 0-2 of explosive gases and in zones 20-22 of explosive dust.
Full text of certificates:
- IECEx: Ex ia IIC T4 Ga / Ex ia IIIC T130 ° C Yes IP66 / IP67
- ATEX: II 1G Ex ia IIC T4 Ga / II 1D Ex ia IIIC T130 °C Yes IP66 / IP67It also meets CSA and PCEC certificates.
Parameter e ATEX lamp Fenix WF11E :
A powerful Cree XP-G2 LED with a warmer shade of light with a lifespan of 50,000 hours is used.
Three power modes: 200 lumens (10 hours) -> 100 lumens (29.5 hours) -> 30 lumens (70 hours).
Uses three AA batteries. Fenix strongly recommends using only battery types that have been certified by the manufacturer: ENERGIZER E91, DURACELL MN1500 and RAYOVAC 815
Protection against accidentally inserting the battery upside down (reverse polarity).
Made of solid antistatic plastic (polycarbonate RTP399 X 133887).
Grooving surface for better grip.
Fixed clasp with integrated magnet.
Magnetic end.
Dustproof and waterproof according to the IP67 standard up to a depth of 1 meter underwater.
Smooth aluminum reflector for a perfect light cone with an afterglow of over 185 meters (8512 cd).
Dimensions 16.75 cm (length) x 4.9 cm (head diameter) x 2.4 cm (body width).
Weight 160 grams (without batteries).
The package includes three Energizer alkaline pencil batteries, which are approved for use in the lamp, a spare o-ring, a strap and a certificate valid for the EU.
To use :
The flashlight is turned on and off by holding the button on the side for 0.5 seconds. The lighting modes can be changed by short presses of the button in the order of low-medium-high.
To replace the batteries, unscrew the lamp head and remove the battery holder. When replacing the batteries, pay attention to the correct polarity marked on the holder. Put the holder back and screw the lamp head.
Warning
Carry out all servicing and battery replacement outside of an explosive atmosphere!
In an explosive atmosphere, use only batteries that have been certified by the manufacturer: ENERGIZER E91, DURACELL MN1500 and RAYOVAC 815
Never mix batteries of different manufacturers, different ages or different degrees of discharge.
For long-term storage, we recommend removing the batteries from the lamp to prevent them from leaking and damaging the lamp.
If the protective rubber rings appear damaged after a long period of use, replace them.
If the light flickers, does not switch to higher power modes, or does not light up, it may be for one of the following reasons:
Batteries are almost empty - replace them.
The contacts inside the lamp are clogged - clean them with a cotton swab dipped in alcohol.
The lamp body is loose, tighten it.
Warranty
Five-year warranty.
Max power: 200lm
Max endurance: 70 hours
Aftersight: 185m
Number of modes: 3
Weight: 160g
Power supply: 3x AA
Light source: Cree XP-G2
Waterproof: IP67 (immersion 1 m)
Product details
| Sport | hiking, alpinism |
| Colour | red, orange |
| Power supply type | none |
| Battery type | battery powered |
| product ID | 131864 |
Rating 0/5
Similar products
You can try these searches
You may find these products complementary
Rear bike lights
More products
Bike lights accessories
More products
Batteries
More products
Bike Computers and GPS Devices
More products
Bike gloves
More products
Why shop with us?
Find out what makes us specialWhy shop with us?
More about shopping
900 000+ orders
We are the largest cycling e-shop in Slovakia proven by 100,000+ customers.
Unique customer service
We are available via email, online chat, phone or in person at our MTBIKER stores.
We actively support the cycling community in Slovakia
Thanks to your order we can support cycling development.
Secure payment methods
The payment process is safe and we offer you a wide range of options.
Loyalty system
We will reward you for your purchase and also for quality contributions in the MTBIKER forum, e-shop, trips and photo gallery.
MTBIKER centre and showroom
Visit our store with a pump-track and trail access or our showroom in a historical bulding in central Bratislava.
comment Reviews
There are currently no reviews