Fenix LED flashlight PD25 + USB battery 700 mAh

Discounted set of Fenix PD25 flashlight and Fenix RCR123A 700mAh Li-ion battery with USB charging.

The high-performance Fenix PD25 flashlight offers a luminous flux of up to 550 lumens (ANSI) and an afterglow of up to 130 meters. One piece of disposable CR123A battery or RCR123A rechargeable battery can be used for power supply (the USB version is part of this set). The latest Cree XP-L LED with an efficiency of up to 200 lm / W is used as a light source. The lamp has five different lighting modes that allow you to choose between high performance and long endurance ( up to 58 hours ). The lamp is powered by a digitally controlled constant current to guarantee constant light output even when the voltage in the batteries is reduced (while they are gradually discharged).

All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

Fenix PD25 flashlight parameters:

• A premium powerful Cree XP-L LED with a lifespan of 50,000 hours is used.

• Five lighting modes:

  • with single-use CR123A battery: 400 lumens (1.2 hours) -> 150 lumens (3.25 hours) -> 50 lumens (9 hours) -> 5 lumens (58 hours) -> Strobe

  • with rechargeable RCR123A battery: 550 lumens (35 minutes) -> 150 lumens (2.5 hours) -> 50 lumens (7 hours) -> 5 lumens (53 hours) -> Strobe

• Operation on the highest mode is limited to 5 minutes at a time, after which the lamp automatically switches to the 150 lumen mode.

• It is possible to use 1x 3V CR123A battery for power supply, as a rechargeable alternative, one rechargeable li-ion battery type RCR123A can be used.

• Digitally regulated for constant brightness.

• A continuous light cone with an afterglow of up to 130 meters (4225 cd).

• Protection against accidentally inserting the battery upside down (reverse polarity).

• Dimensions 9.3 cm (length) x 2.15 cm (diameter). Weight 47 grams (without batteries).

• Made of T6 aviation hardened aluminum.

• The lamp has a memory and will always turn on in the last set mode (does not apply to flash mode).

• Durable surface - Type III hard anodized.

• Impact resistant to a drop from a height of 1 meter.

• Prominent indentation of the surface for a better hold, the design prevents the lamp from rolling on an uneven surface.

• Waterproof according to the IPX-8 standard (tested under water at a depth of 2 meters for 30 minutes).

• Hardened ultra clear glass lens with anti-reflective coating.

• Tactical switch at the end of the light (momentary on / off function).

• The light comes with a wrist lanyard, steel clip, belt pouch and spare o-ring and RCR123A battery with USB.

• Optional original accessories can be purchased: diffuser AOD-S, red filter AOF-S, traffic cone AOT-S or a strap for using the lamp as a headlamp.

• The AB02 swivel case, bicycle lamp holder, BikeBlock bicycle helmet holder, Fenix ALB-10 bicycle holder or spare battery RCR123A with micro-USB connector or spare battery with a capacity of 800 mAh are also compatible with the lamp.

The use:

To turn it on, press the switch located at the end of the lamp, for immediate activation, hold down the button. By pressing the side button on the lamp head, you can switch between power modes at any time during operation. To switch to strobe mode, hold down the side button for about 1 second.

Notice:

• Do not disassemble the sealed part in the lamp head yourself, this will void the warranty.

• Use only high-quality CR123A or RCR123A batteries.

• If the protective rubber rings appear damaged after a long period of use, replace them. The rings must also be lubricated to prevent rubber erosion. By following these rules, the lamp will be properly protected against water.

• If the lamp flashes, does not switch to higher power modes, or does not light up, it may be for one of the following reasons:

  • Batteries are almost empty - replace them.

  • The contacts inside the lamp are dirty - clean them with a cotton swab dipped in alcohol.

  • The head, body or back of the lamp is loose - add lubricant to the sealing rings and tighten the head and the end of the lamp.

Warranty:

Five-year warranty for the flashlight, two years for the accumulator.

Weight: 47g
Number of modes: 5
Afterlight: 130m
Output: 550lm
Max. duration: 58 hours
Power supply: 1x CR123A
Power supply: 1x RCR123A
Light source: Cree XP-L
Waterproof: IPX8 (immersion 2 m)